system description
2-2 Rad-5/5v Signal Extraction Pulse Oximeter Operator’s Manual Rad-5/5v Signal Extraction Pulse Oximeter Operator’s Manual 2-3
2
2
system description
CONTROL / INDICATOR DESCRIPTION
1
Patient Cable
Connector
Connects to LNOP DCSC Spot Check sensor or Masimo
Patient Cable
2
FastSat Indicator
Illuminates when the FastSat mode has been enabled.
FastSat enables rapid tracking of arterial oxygen saturation
changes
3
Saturation Display
The functional arterial hemoglobin oxygen saturation is dis-
played in units of SpO
2
. When searching for a saturation
and pulse, it will flash dashed lines.
4
Signal IQ /
Pulse Bar
The Signal IQ provides an indication of the quality of the
acquired signal as well as the timing of the pulse. A green
vertical LED bar rises and falls with the pulse, where the
height of the bar indicates the quality of the signal.
5
Pulse Rate Display
The pulse rate in beats per minute (bpm). When searching
for a saturation and pulse, it will flash dashed lines.
6
Mode / Enter Button
Used to enter the setup menus and to select/activate certain
entries within the menu/setup system.
7
Next Button
Used within the menu/setup system to move through setup
options. Not active during normal patient monitoring.
CONTROL / INDICATOR DESCRIPTION
8
Power On / Off
Used to turn the unit on and off.
9
Battery Level
Indicator
Four LED’s indicate the status of the battery. When the final indi-
cator begins flashing, replace the batteries.
10
Visual Alarm
Indicator
Illuminates when any alarm condition exists. This indicator may
not be turned-off or otherwise over-ridden.
11
Perfusion Index
The Perfusion Index provides an indication of the percentage of
pulsatile signal to non pulsatile signal. The bar is highest when
the quality of the perfused site is best.
12
MAX Sensitivity
Indicator
Illuminates when the MAX Sensitivity mode has been enabled.
Note:
When using the Maximum Sensitivity setting, the SENSOR
OFF detection performance may be compromised.
13
Alarm Silenced
Indicator
Flashes to indicate the alarm is temporarily silenced (by pushing
the Alarm Silence Button once) or is illuminated solid to indicate
the alarms have been permanently muted (by pushing the Alarm
Silence Button twice) .
14
Alarm Silence
Button
Push once to temporarily silence the alarm for 120 seconds.
Push a second time to permanently mute (suspend) the alarm. A
third push will return the unit to standard alarm monitoring.
15
Up button
Down button
During saturation monitoring, use these buttons to adjust the vol-
ume of the pulse beep tone.
Within the menu/setup system, these buttons are used to select
values within each menu option.
17
Speaker
Provides audible indication of alarm conditions, pulse tone and
feedback for key-presses. Ensure the speaker is not covered or
the unit is placed face-down on bedding or other sound absorbing
surface.
18
Pulse Tone
Volume
Provides control of the pulse tone volume. Cycles through three
volume levels, and mute. At the loudest level, pressing the Pulse
Tone Volume button will return the volume to mute.
19
Display Brightness
Provides control of the front panel indicator brightness. Cycles
through four brightness levels. At the brightest level, pressing the
Display Brightness button will return the display to the lowest
brightness setting.
(116 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce